The large rotor hammer mill is a machine made entirely from heavy-gauge steel, with two side doors for easy and quick access to the grinding chamber, screens and hammers. The machine consists of a sturdy base, made of welded “U” profiles, to which are anchored the mill and the motor, which is connected directly to the shaft with a flexible joint in between. The base rests on anti-vibration feet to dampen the vibrations that are transmitted. The heavy-duty construction and large dynamically-balanced rotor allow for operation with minimal vibration. The diameter of the rotor, which is larger than standard models, allows the installation of 4-pole motors, while still guaranteeing optimum peripheral speed. The walls in contact with the grain are made of wear-resistant steel that is 15 to 20 mm thick and are interchangeable, thus allowing long life of the mill. At the top of the structure there is a double-wing inlet diffuser for diverting the flow in one of two directions. The product is crushed by means of a series of hammers made from a special hardened alloy that can be rotated for better utilization on both sides. The shaft is coupled to the electric motor by a flexible coupling and drives the hammers in rotation. The product is intercepted by the screens supported by the frame with chain hinges and a tensioner. The release/coupling system is made with two electropneumatically controlled cylinders that allow replacement of the screens even with the mill in motion without opening the doors, as this operation takes place at the front of the machine by means of special handles. Screen and hammer replacement is extremely simple and quick. The machine is equipped with all the necessary safety devices, including sensors that stop operation if the doors are opened, ensuring the protection of the operator during every stage of use and maintenance.